Press and release RECALL, then hold the RECORD button for about three seconds until the mode button is lit again.Select the type of learning you wish to perform:.On the DISH Network remote, press and hold the mode button for your equipment for about three seconds until all of the mode buttons light up, and then release it.Place both the DISH Network remote and the original equipment's remote control on a flat, stable surface.Ensure the DISH Network remote control is programmed to the desired remote address to operate the DISH Receiver.Maintain unobstructed LOS while the green progress bar fills.Maintain unobstructed LOS while the green progress bar fills. Select Continue twice to initiate data transfer.Select the type of backup to be performed:.Verify that the purple gem is displayed beside the correct selection.Verify that the System Wizard says the remote is configured correctly.Press and hold the number 0 until the pop-up 380 appears on the screen.The customer will need to direct the remote toward the receiver for the duration of the System Wizard setup. Verify that the customer has an unobstructed LOS and is within 10 feet of the receiver.I have provided instructions on how to save setting on the receiver and remote plus instructions for learning mode.
0 Comments
Leave a Reply. |